2pc F*CK IT EDITION emblem Badges Sticker Decal for Chevy Car Truck Universal

Description

You may also like
Gray For 07-14 Chevy Silverado1500 2500HD 3500HD Driver Bottom Cloth Seat Cover
35.89 USD
Free shipping
Rearview Mirror Decoration Carbon Fiber 5D Sticker Stripe Decal Car Accessories
4.89 USD
Free shipping
2 PCS Xenon White LED Background Light Sticker For BMW Logo Emblem
12.88 USD
Free shipping
10ft Car Door Protector Scuff Cover Antiscratch Carbon Fiber Strip Sticker
6.34 USD
Free shipping
Quick Release Locking Hood Latch Pin Kit - Black or Carbon Fiber - Universal Fit
27.89 USD
Free shipping
Car Gear Handlebar Carbon Fiber Stickers on Both Sides For 15-20 Ford Mustang
4.59 USD
Free shipping
Rubber Seal Trim Edge Protector For Car Windshield Door Window Replacement 5 FT
8.99 USD
Free shipping
Universal Auto Rubber Seal Weather Strip Door Window Lock Trunk Hood Edge Trim
19.89 USD
Free shipping
2pc F*CK IT EDITION emblem Badges Sticker Decal for Chevy Car Truck Universal
Feture:
3D Dome Surface
100% brand new and high quality guaranteed
Decorate your car charming luxury vivid
Easy to use and to operate at affordable prices
Perfect cover that is useful,helpful and so practical
Automotive Adhesive for Long Lasting Installation
Easy to use and to operate
Never fade & Water Proof
3 1/8 x 1 1/4 or 80mm x 30mm
Actual emblem, not a thin sticker
Package：
2pc Emblem Set
Installation Instructions
1. Removing old emblem or emblems can done neatly by using a heat gun on the lowest setting. Carefully pry the old emblem off using a      putty scraper.
2.Then clean the area where the emblem adhesive still remains. Use adhesive cleaner and a clean rag.
3.Most important step is to use rubbing alcohol on a different rag to clean the remaining grease or dirt from the location. Allow it to air dry.
4.Using a level or ruler to create a straight line parallel to the ground, marking the location of the emblem against desired surface or body   lines. Use painter’s tape to make your guide lines.
5.Prepare the emblem, making sure it's clean. Be sure to never touch the application adhesive on the back of the emblem after  Remove   the backing tape from the adhesive.
6.Hold the emblem just above the surface in the desired location, using the painter’s tape as a guide to keep the emblem level located   properly.
7.Stick the emblem on and hold it in place until the adhesive has had a chance to setup bond on the surface of the vehicle. This usually   takes 10 seconds..